Pump and Fluid ends

Over view 

The UHP pump is the heart of any water jetting systemand Hypiont‘s pumps are designed for maximum performance with minimal wear, cycle after cycle.

The Hypiont H-stream  Series pump is an advanced design triplex pump with exceptional flexibility and versatility to efficiently meet the requirements of a wide range of pumping services.  It provides a powerful performance and dependable reliability needed to meet heavy-duty demands of continuous operation while keeping maintenance to a minimum. 

Combining industry-leading consultative solutions and a simple-to-operate and maintain design, our flexible, easily-configurable unit efficiently meets your needs in any application.        

Hypiontpump is available with either an internally or non-internally geared power end.  

Need a unit you can operate at different pressures, up to 40,000 psi (2,800 bar). We have many models for  you choose .
There are many reasons contractors and industry specify Hypiont pump units, but here are the ones we hear most often:

 •      High efficiency (up to 98%) with consistent performance

 •      Low operating cost

 •      Fast, easy maintenance 

       Advanced engineering and long-life body 

Fluid end features 

 •      Easily configured for operating pressures from 6,000 to 40,000 psi within 15mins . A single stainless steel frame plate and swing-out manifold is used for all operating pressures
 •      The design features minimum volumetric clearance and stress, with maximum shock and pressure resistance
 •      Passages are drilled to minimize turbulence
 •      The valve seat and stuffing boxes are precision-machined from high-grade stainless steel
 •      Stainless steel valves have a hard, double guided design that improves valve life by ensuring alignment.  Seats are beveled and are also made from hardened stainless steel
 •      Long-Life Power End  
 •      Compact design with internal gear reduction 
 •      Pressure lubricated 
 •      High water temperature operation  
 •      Advanced trunnion design for superior support .
 •      Protection for the power end through low oil pressure and high temperature switches               
 •      Water loop cooling to prevent overheating in all weather conditions

Power Frame Features 

 •      Horizontal configuration provides easy access and low center of gravity.
 •      Rugged, cast-iron housing with gravity lubrication and large oil reservoir.
 •      Forged steel crankshaft mounted in heavy duty bearings.
 •      Drive pinion output shafts on both sides of pump allow for opposite-hand drive. 
 •      Internal gearing eliminates the need for large pulleys or belts, greatly decreasing the pump’s overall footprint.  
 •      Large-diameter cylinder crossheads operating in full circular guides, fitted with hardened wrist pins
 •      Ground crosshead stub shafts with lipped seals to keep water and dust out of crankcase.


For more information on Pump and Fluid ends >>